Dent breakaway bolts8/9/2023 ![]() ![]() The breakaway screw should never be longer than the allowed insertion point in the knob to keep the cabinet knobs in uniform with the other knobs. The rule of thumb is the screw length must either exact fit to the knob or it’s a bit shorter.If it falls on the threaded part of the breakaway screw, move the breaking point to the notch closer to the head. To install, choose optional mounting hardware: standard J-bolts or Dent breakaway compliant bolts. You can either use a marker or leave a small dent. 3' diameter fluted post, 3-bolt surface mount, black finish. Check the end of your desired screw length and mark it as your breaking.Once you get the desired length, start measuring from the base of the head of the screw.Total screw length: depth of wood panel + ¼” (depth of knob insertion) To get the actual length of the breakaway screw that you need, add ¼” to the total depth of the wood.Measure the depth of the wood or drawer panel.Start measuring the desired screw length with the following steps: ![]() To get accurate measurements, you can use a measuring tape or make a dent on the breaking point. You’ll have to check the depth of both cabinet door panels and the insertion point in the knobs. The depth of the drawer refers to the thickness of the wood where the cabinet knobs will be attached. How To Measure The Breaking Point in a Breakaway Screw? The score, notch, or breaking point is a dented part of the breakaway screw where you can break the screw with ease. Unthreaded shank is the unthreaded part of the screw.Screw drives are the indentation on top of the head of the screw where you attach the screwdriver that you use to tighten or loosen the screw.The head of the screw is the head of the screw where you place the tip of the screwdriver to tighten or loosen the screw.Screw threads or threads are the helix-shaped ridges around the body of the screw.Here are the parts of the breakaway screw that you should familiarize yourself with: Depending on the thickness of the wood or the design of the knob, you can modify the size of the screw by breaking it at your desired length. The beauty of breakaway screws is its flexibility when it comes to its size. 8-32 X 1 – ¾ Truss #2 Phillips drive breakaway machine screw – Zinc – 4M/CTN.8-32 X 1 – ⅛ Truss #2 Phillips drive breakaway machine screw – Zinc – 6.5M/CTN.8-32 X 1 – ¼ Truss #2 Phillips drive breakaway machine screw – Zinc – 5.5M/CTN. ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |